How to Clean a Vacuum for Stronger Suction and Peak Performance?

One of the most important things you can do to increase your cleaning effectiveness is to clean your vacuum cleaner thoroughly before each use. The suction power of your vacuum is directly related to how clean the filters are. When your filters are dirty, you’ll notice that the suction power will drop. And when your filters are clogged, the suction power will be almost nonexistent. A clogged filter will make it impossible for your vacuum to suck up all of the dust, dirt, hair, and other debris that you’re trying to remove. The first step to cleaning your vacuum effectively is to make sure that the filter is clean and ready to go.

Clean your vacuum regularly. Using a vacuum cleaner without cleaning the dirt out of it can lead to problems like clogged vents and a burnt motor. This video will show you how to clean your vacuum properly so that it works better and lasts longer.

Step 1 – Remove the dust cover and brush from the vacuum head

Take the dust cover and brush off the head by turning them counterclockwise. You can use a rubber glove or a small paintbrush if you don't have a tool.

Step 2 – Clean the filter

The filter is located at the bottom of the vacuum head. Simply use the WindTunnel® to remove the dirt from the filter.

Step 3 – Disassemble the vacuum

Disassemble the vacuum by unscrewing the screws on the back of the vacuum.

Step 4 – Clean the motor

Take the brushes and the roller away from the motor and clean it.

Step 5 – Remove the hose from the back of the vacuum

Carefully pull the hose away from the vacuum and remove the nozzle. Then, remove the hose and put it somewhere safe to store.

Step 6 – Remove the brush rollers

Carefully remove the brushes and the roller. Make sure you don't touch the brush rollers with your hands. They are very sharp.

Step 7 – Clean the motor housing

Use WindTunnel® to clean the inside of the motor housing. This is important because dust can get stuck in the motor and cause it to break down.

Step 8 – Clean the filter bag

Clean the filter bag and shaking it around. You can also use a vacuum cleaner brush to clean it out.

Step 9 – Replace the nozzle

Put the nozzle back on the vacuum and put the hose back into it.

How to Disinfect a Vacuum?

You can also use a vacuum cleaner to clean your carpet. You just need to turn the vacuum upside down and run it over the carpet. You can clean the carpet by running the vacuum over it, or you can use a vacuum cleaner brush to do this.

In conclusion, there are a few things that you can do to make your vacuum cleaner work better. First, you should make sure that your vacuum is plugged in and turned on. If it’s not plugged in, it won’t be able to suck up dirt and debris.